Tyco P700WLS Manuel d'utilisateur télécharger pdf (Page 11)

Installation Manual P700WLS ioProx Receiver

DN1628-0806

Testing the Receivers

PCB LED Indicators

All LEDs are located on the PC board, inside the box.

Figure 3 LEDs Location

Y4:

Flashes if the transmitter encryption code does not match the receiver configuration, and

will not operate the receiver. Check that the transmitters are programmed to operate with

this receiver.

Y5:

Flashes when the transmitter code is valid.

Y6:

RF activity indicator. The LED will flicker to indicate the receiver has power. If the LED

remains on steady, there is a continuous 433 MHz signal that will prevent the unit from

operating reliably.

Y8:

Flashes when the Wiegand information is sent.

Y9:

Controlled externally by the access control panel. Typically this is controlled by the access

control panels LED confirmation output (Brown wire). The Y9 LED is located on the PC

board, inside the box.

Y10

Power indicator.

LED Location

1 2 ... 6 7 8 9 10 11 12 13

Pas de commentaire

Tyco P700WLS Manuel d'utilisateur Page 11