Tyco 1928L Manuel d'utilisateur télécharger pdf (Page 33)

3-19

C H A P T E R

TROUBLESHOOTING

If you are experiencing trouble with your touchmonitor, refer to the following table. If the prob-

lem persists, please contact your local dealer or our service center. Elo Technical Support num-

bers are listed on page 31 of this manual.

Solutions to Common Problems

Problem Suggestion(s)

The monitor does not respond Check that the monitor’s Power Switch is on. You turn on the

system.Turn off the power and check the monitor’s power cord

and signal cable for proper connection.

Characters on the screen are dim Refer to the Controls and Adjustments section to adjust the brightness.

The screen is blank During operation, the monitor screen may automaticallyturn off as

a result of the Power Saving feature. Press any key to see if the

screen reappears.

Refer to the Controls and Adjustments section to adjust the brightness.

OSD or power buttons don’t work Check to see that they are not locked. See page 15.

“Out of Range” display” Check to see of the resolution or vertical frequency of your

computer is higher than that of the LCD display.

Reconfigure the resolution of your computer to make it less than or

equal to 1280 x 1024. 1280 x 1024 is optimal. See Appendix A for

more information on resolution.

Touch doesn’t work Make sure cable is securely attached at both ends.

Power will not shut off immediately Be sure to depress power button for five(5) seconds when powering

off. Unit includes integrated power down delay function.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 54 55

Pas de commentaire

Tyco 1928L Manuel d'utilisateur Page 33